Seats and tools
masonjs at nrtco.net
Sat May 23 09:16:57 PDT 2009
There are 2 smaller allen head bolts on each side of the wheel, that clamp
the main axle shaft. Loosen them first. If you still have the original
tools under the seat then there should be an allen key to fit the small
bolts. I believe the axle shaft is a 12 mm.
----- Original Message -----
From: "Jonathon Jay" <annihilator1100 at hotmail.com>
To: "Kawasaki GPZ1100 discussion" <gpzlist at micapeak.com>
Sent: Saturday, May 23, 2009 11:45 AM
Subject: Seats and tools
> Got the seats off. I'm a dumbass. I was trying to get it off by using the
> key on the helmet lock slot on the right side of the bike. This is what
> happens when you don't ride for 10 years.
> On the subject of tools. I'm going to be sending my forks off to Race Tech
> but need to get the front wheel off. What tool do you guys use for the
> main axle bolt? Again, an Allen head, 6 points, appears to be a 12mm. I
> really don't want to round it out like I did on my caliper bracket.
> Please, someone respond so I can go take a trip to Lowe's.
> What's The Difference Between Ignorance And Apathy?
> ~ I Don't Know And I Don't Care ~
> Hotmail® goes with you.
More information about the GPZList