Compression/Octane

[Randy Grein]

Should be. Mine was 13.8:1 and 100 octane is, or was fine with it.
Randy Grein, WMRRA #41

On May 13, 2008, at 8:13 AM, Steve Robertson wrote:

> I just measured the compression ratio of my motor and after a few  
> screw-ups
> (clarified thanks to Z) I'm fairly confident that the compression is  
> 12.5:1. For
> those of you running a similar number is 100 octane enough to avoid  
> detonation
> or would a few more points be needed? If it makes any difference the  
> heads have
> not been milled and I am running a full three layer head gasket.
>
> thanks,
> Steve