Cam Timing Problems

[zoran]

not necesary cams wrong,reading numbers from wheel.you are way off there.  


Zoran Vujasinovic
Twin Works Factory
775-786-4881
www.twfracing.com 
----- Original Message ----- 
From: "Steve Robertson" <srobertson at ssimicro.com>
To: "Suzuki SV650 Mailing List" <sv650 at micapeak.com>
Sent: Friday, October 10, 2008 9:23 PM
Subject: Re: Cam Timing Problems


> Hmmm, not what I wanted to hear :-(   Guess it will all have to come
> apart again, hopefully I can figure out where I went wrong. I had the
> front cylinder at TDC and then rotated the crank 360deg. The marks
> on the stock cams in the rear cylinder were just like it showed in the 
> manual so I removed them and installed the others at the same marks. 
> Did I miss something?
> 
> Steve
> 
> 
>> formula is correct,(opening+closing+180)/2=?-smaller number=lobe center.
>> your opening and closing numbers are wrong.
>> 
>> 
>> Zoran