Inner clutch cover

[zoran]

yes, just don't hammer it.
you can use hammer as pry bar between tabs and cases.


Zoran Vujasinovic
Twin Works Factory
775-786-4881
www.twfracing.com
----- Original Message ----- 
From: "Wendell Crain" <wendell_crain at hotmail.com>
To: <sv650 at micapeak.com>
Sent: Saturday, March 14, 2009 2:52 PM
Subject: RE: Inner clutch cover



Cool. A beer sounds good right now!

Would the spots be the small tab? One on the bottom, one on along the right 
or forward side, and I am guessing that the third would be towards the rear? 
Is the bottom of that case ok to leverage the pry bar on?

Thanks!

Wendell

> From: zv30 at sbcglobal.net
> To: sv650 at micapeak.com
> Subject: Re: Inner clutch cover
> Date: Sat, 14 Mar 2009 13:53:24 -0700
>
> lean bike on left side. drain oil, have beer and come back in few hours.
> fish washer with magnet.
> there are 3 spots on cover where you can use pry bar to unglue it from
> cases. make sure all bolts are out before doing it. 3 bolts that hold 
> water
> pump also hold cover to case.
>


_________________________________________________________________
Windows Live™ Groups: Create an online spot for your favorite groups to 
meet.
http://windowslive.com/online/groups?ocid=TXT_TAGLM_WL_groups_032009=