WTB 1st gen blue gas tank
wendell_crain at hotmail.com
Wed May 6 13:25:52 PDT 2009
Perfect. I will have to give that a go. I was going to try to JB Weld it, but this would be better.
> From: zv30 at sbcglobal.net
> To: sv650 at micapeak.com
> Subject: Re: WTB 1st gen blue gas tank
> Date: Wed, 6 May 2009 13:12:29 -0700
> I use tig but mig would work, it is steel.
> you do have to wash tank before welding. I use soap and pressure washer to
> make sure there are no fumes in there.
> if not in rush I keep tank empty and wented for months and than wash it.
> Zoran Vujasinovic
> Twin Works Factory
> ----- Original Message -----
> From: "Wendell Crain" <wendell_crain at hotmail.com>
> To: <sv650 at micapeak.com>
> Sent: Wednesday, May 06, 2009 1:09 PM
> Subject: RE: WTB 1st gen blue gas tank
> What do you use to weld it? Would a mig work if on a light setting? I have
> one from last fall that broke and have not fixed yet.
> > From: zv30 at sbcglobal.net
> > To: sv650 at micapeak.com
> > Subject: Re: WTB 1st gen blue gas tank
> > Date: Wed, 6 May 2009 13:02:34 -0700
> > yes, weld it. I did it on every tank I have.
> > send me tank and I will do it.
> > it is not your cap, it is that tube. I am pretty sure there is nothing
> > wrong
> > with your cap. water just passes around outer lip of cap under it and than
> > through tube hole in tank.
> > also gas comes out through that hole and you can probably smell it.
> > Thanks
> > Zoran Vujasinovic
> > Twin Works Factory
> > 775-786-4881
> > www.twfracing.com
> Insert movie times and more without leaving Hotmail®.
Windows Live™: Keep your life in sync.
More information about the SV650