2mm pistons...

KC Gager kc at brgracing.com
Mon Sep 14 23:12:08 PDT 2009


It all depends on the compression you are looking to get. How much did you
mill the heads

 
 
The Home of A Sickness for Quickness
K.C.  Owner of BRG Racing Products and Dyno Services
kc at brgracing.com
Shop # 925-680-2560 
Toll Free # 1-877-ride-brg 
Address
110 2nd Ave South Unit D 12
Pacheco Ca 94553
 

-----Original Message-----
From: sv650-bounces at micapeak.com [mailto:sv650-bounces at micapeak.com] On
Behalf Of Chris Burgess
Sent: Monday, September 14, 2009 9:42 PM
To: Suzuki SV650 Mailing List
Subject: Re: 2mm pistons...

I don't know.  This is why I am asking.  I presume one doesn't generally
mill the head when you go to 2mm overbore pistons.  Sounds like I'm
incorrect.

On Mon, Sep 14, 2009 at 9:32 PM, zoran <zv30 at sbcglobal.net> wrote:

> why would you need new head?
>
>
> Thanks
>
> Zoran Vujasinovic
> Twin Works Factory
> 775-786-4881
> www.twfracing.com
>
> ----- Original Message ----- From: "Chris Burgess" <chris at chrisburgess.com
> >
> To: "Suzuki SV650 Mailing List" <sv650 at micapeak.com>
> Sent: Monday, September 14, 2009 9:18 PM
> Subject: 2mm pistons...
>
>
>
> Perhaps a dumb question but...but if one were to convert a SS motor which
>> has had its heads machined for compression...they would or would not need
>> new heads if they wanted to go the route of 2mm over pistons and things
of
>> that sort?
>>
>> Thanks.
>>
>
>
>


-- 
WERA #104
OMRRA #104
WMRRA #104
http://www.burgiracing.com
http://www.sponsorhouse.com/members/thatman

2009 Sponsors
I-90 Motorsports
Vortex Racing - http://www.vortexracing.com
Motorex - http://www.motorex.com
Lockhart Phillips http://www.lockhartphillipsusa.com



More information about the SV650 mailing list