1 st generation crank shaft

Dan Chrystal dchrysta at columbus.rr.com
Thu Jun 3 20:02:15 PDT 2010


When I compared them this morning they looked close, but seemed to have some
subtle differences, is it a drop in, just follow the end play measurement
per the 1 st gen manual? Anything else to watch for?

Thanks,

Dan

On Thu, Jun 3, 2010 at 10:43 PM, zoran <zv30 at sbcglobal.net> wrote:

> They are, you can use either one in either motor.
>
>
> Thanks
>
> Zoran Vujasinovic
> Twin Works Factory
> 775-786-4881
> www.twfracing.com
> ----- Original Message ----- From: "Ernest Montague" <afm199 at earthlink.net
> >
> To: "Suzuki SV650 Mailing List" <sv650 at micapeak.com>
> Sent: Thursday, June 03, 2010 7:40 PM
> Subject: Re: 1 st generation crank shaft
>
>
>
>  Not really
>>
>> gen one can fit gen two with shims
>>
>>
>> On Jun 3, 2010, at 7:38 PM, Steve Robertson wrote:
>>
>>  I thought cranks were interchangeable, no?
>>>
>>>  I need a 1 st generation crank shaft, I have a good second generation
>>>> crank shaft with rods. Anyone have one they would like to trade?
>>>> Dan
>>>>
>>>
>>>
>>


More information about the SV650 mailing list