steel braided lines -- any trick to get fluid flowing?

Jo Rhett jorhett at
Sun Oct 10 14:56:47 PDT 2010

On Oct 10, 2010, at 2:30 PM, Chris Burgess wrote:
> Leave the cap off your master cylinder and fill it up.  Attach a bleed
> hose to the bleeder at the caliper.  Crack the bleeder open and leave
> it open.  It'll eventually drain fluid though...don't crack it wide
> open but enough for fluid to come through.

Yeah, basic of bleeding 101 ;-)  I had been doing that for about 30 minutes when I came inside to write the message.  Apparently I was nearly there, and just needed a bit more patience.

Jo Rhett /  velociRaptor Racing
#553 WERA

More information about the SV650 mailing list