GSXR Fork Conversion dust seal?

[Henrik Bo Pedersen]

Thanks Zoran,

So I fit the GSXR type seal between the bearing and the tension nut - right?

Henrik

On Jul 4, 2011, at 8:18 PM, Zoran wrote:

> You can not use stock sv seal, you have to use gsxr one.
> 
> 
> 
> Thanks,
> 
> Zoran Vujasinovic
> TWF Racing
> 775-786-4881
> www.twfracing.com
> 
> 
> 
> 
> On Jul 4, 2011, at 4:11 PM, Henrik Bo Pedersen wrote:
> 
>> I'm finally getting around to putting GSXR forks on my 1999 SV using Zoran's bearing kit.
>> 
>> Question: What do you guys recommend for dust seal at the top bearing?
>> 
>> At the bottom I used what I think is the GSXR seal: a thin brass finish metal washer with a rubber sealing edge. It fit nicely up into the SV steering head.
>> 
>> The SV rubber cup could fit between the top bearing and the tension nut - the one with notches for a hook spanner - and would seal around the top of the steering head.
>> 
>> The GSXR type would fit in the same spot between the bearing and the tension nut and might seal onto the top of the steering head.
>> 
>> What say ye?
>> 
>> Thanks,
>> 
>> Henrik
>