GSXR Fork Conversion dust seal?

Zoran zv30 at sbcglobal.net
Mon Jul 4 17:33:32 PDT 2011


Tried to post instructions here but don't think it will go.
Email me direct and I will send you copy.



Thanks,

Zoran Vujasinovic
TWF Racing
775-786-4881
www.twfracing.com




On Jul 4, 2011, at 5:21 PM, Henrik Bo Pedersen wrote:

> Thanks Zoran,
> 
> So I fit the GSXR type seal between the bearing and the tension nut - right?
> 
> Henrik
> 
> On Jul 4, 2011, at 8:18 PM, Zoran wrote:
> 
>> You can not use stock sv seal, you have to use gsxr one.
>> 
>> 
>> 
>> Thanks,
>> 
>> Zoran Vujasinovic
>> TWF Racing
>> 775-786-4881
>> www.twfracing.com
>> 
>> 
>> 
>> 
>> On Jul 4, 2011, at 4:11 PM, Henrik Bo Pedersen wrote:
>> 
>>> I'm finally getting around to putting GSXR forks on my 1999 SV using Zoran's bearing kit.
>>> 
>>> Question: What do you guys recommend for dust seal at the top bearing?
>>> 
>>> At the bottom I used what I think is the GSXR seal: a thin brass finish metal washer with a rubber sealing edge. It fit nicely up into the SV steering head.
>>> 
>>> The SV rubber cup could fit between the top bearing and the tension nut - the one with notches for a hook spanner - and would seal around the top of the steering head.
>>> 
>>> The GSXR type would fit in the same spot between the bearing and the tension nut and might seal onto the top of the steering head.
>>> 
>>> What say ye?
>>> 
>>> Thanks,
>>> 
>>> Henrik
>> 
> 



More information about the SV650 mailing list