GSXR Fork Conversion dust seal?

Randy Grein rgrein at q.com
Tue Jul 5 00:04:15 PDT 2011


Got stuck in the list. I just released it....
On Jul 4, 2011, at 5:33 PM, Zoran wrote:

> Tried to post instructions here but don't think it will go.
> Email me direct and I will send you copy.
>
>
>
> Thanks,
>
> Zoran Vujasinovic
> TWF Racing
> 775-786-4881
> www.twfracing.com
>
>
>
>
> On Jul 4, 2011, at 5:21 PM, Henrik Bo Pedersen wrote:
>
>> Thanks Zoran,
>>
>> So I fit the GSXR type seal between the bearing and the tension nut  
>> - right?
>>
>> Henrik
>>
>> On Jul 4, 2011, at 8:18 PM, Zoran wrote:
>>
>>> You can not use stock sv seal, you have to use gsxr one.
>>>
>>>
>>>
>>> Thanks,
>>>
>>> Zoran Vujasinovic
>>> TWF Racing
>>> 775-786-4881
>>> www.twfracing.com
>>>
>>>
>>>
>>>
>>> On Jul 4, 2011, at 4:11 PM, Henrik Bo Pedersen wrote:
>>>
>>>> I'm finally getting around to putting GSXR forks on my 1999 SV  
>>>> using Zoran's bearing kit.
>>>>
>>>> Question: What do you guys recommend for dust seal at the top  
>>>> bearing?
>>>>
>>>> At the bottom I used what I think is the GSXR seal: a thin brass  
>>>> finish metal washer with a rubber sealing edge. It fit nicely up  
>>>> into the SV steering head.
>>>>
>>>> The SV rubber cup could fit between the top bearing and the  
>>>> tension nut - the one with notches for a hook spanner - and would  
>>>> seal around the top of the steering head.
>>>>
>>>> The GSXR type would fit in the same spot between the bearing and  
>>>> the tension nut and might seal onto the top of the steering head.
>>>>
>>>> What say ye?
>>>>
>>>> Thanks,
>>>>
>>>> Henrik
>>>
>>
>



More information about the SV650 mailing list