GSXR Fork Conversion dust seal?

Zoran zv30 at sbcglobal.net
Tue Jul 5 00:55:40 PDT 2011


Because there was picture attached :)
He has copy, emailed him direct.



Thanks,

Zoran Vujasinovic
TWF Racing
775-786-4881
www.twfracing.com




On Jul 5, 2011, at 12:04 AM, Randy Grein wrote:

> Got stuck in the list. I just released it....
> On Jul 4, 2011, at 5:33 PM, Zoran wrote:
> 
>> Tried to post instructions here but don't think it will go.
>> Email me direct and I will send you copy.
>> 
>> 
>> 
>> Thanks,
>> 
>> Zoran Vujasinovic
>> TWF Racing
>> 775-786-4881
>> www.twfracing.com
>> 
>> 
>> 
>> 
>> On Jul 4, 2011, at 5:21 PM, Henrik Bo Pedersen wrote:
>> 
>>> Thanks Zoran,
>>> 
>>> So I fit the GSXR type seal between the bearing and the tension nut - right?
>>> 
>>> Henrik
>>> 
>>> On Jul 4, 2011, at 8:18 PM, Zoran wrote:
>>> 
>>>> You can not use stock sv seal, you have to use gsxr one.
>>>> 
>>>> 
>>>> 
>>>> Thanks,
>>>> 
>>>> Zoran Vujasinovic
>>>> TWF Racing
>>>> 775-786-4881
>>>> www.twfracing.com
>>>> 
>>>> 
>>>> 
>>>> 
>>>> On Jul 4, 2011, at 4:11 PM, Henrik Bo Pedersen wrote:
>>>> 
>>>>> I'm finally getting around to putting GSXR forks on my 1999 SV using Zoran's bearing kit.
>>>>> 
>>>>> Question: What do you guys recommend for dust seal at the top bearing?
>>>>> 
>>>>> At the bottom I used what I think is the GSXR seal: a thin brass finish metal washer with a rubber sealing edge. It fit nicely up into the SV steering head.
>>>>> 
>>>>> The SV rubber cup could fit between the top bearing and the tension nut - the one with notches for a hook spanner - and would seal around the top of the steering head.
>>>>> 
>>>>> The GSXR type would fit in the same spot between the bearing and the tension nut and might seal onto the top of the steering head.
>>>>> 
>>>>> What say ye?
>>>>> 
>>>>> Thanks,
>>>>> 
>>>>> Henrik
>>>> 
>>> 
>> 
> 



More information about the SV650 mailing list