Fork brace

[Paul Heim]

Jim:

GPz bars have the welded-in insert with female threads.  Bar ends screw in 
with no expanding plugs, etc.  So you'll need more hardware to make the GPz 
bar ends work.

Regards,
Paul in Ohio

-----Original Message----- 
From: Marilyn Mason
Sent: Sunday, May 08, 2011 8:24 AM
To: Paul Heim
Subject: Re: Fork brace

The ID of my bars is 0.697 " .  I took the damaged bar end off and now I
can't find it.  Damn I hate when I do that.

Jim


______________________________________________________________________
GENERAL GPZList MAILING LIST INFORMATION:
This is from the GPZList mailing list. GPZList at micapeak.com
http://micapeak.com/mailman/listinfo/gpzlist
You subscribed to this mailing list. Therefore, you solicited all
mail that you receive from this list. Therefore, ANY mail that you
receive from this list is, by definition, NOT Spam, and if you report
it as such, you are violating the micapeak.com terms of service.

To unsubscribe, you may send email to gpzlist-unsubscribe at micapeak.com
______________________________________________________________________
YOUR PERSONAL SUBSCRIBER OPTIONS:
Unsubscribe or choose new options at
http://micapeak.com/mailman/options/gpzlist/pmheimjr%40gmail.com
You are subscribed at the email address pmheimjr at gmail.com
______________________________________________________________________