Carb Rebuild - Float Height

[Art Johnson]

Pete that is the correct dimension.

Sent from my iPhone

> On Jun 20, 2015, at 6:02 PM, pete weaver <peteweaver at gmail.com> wrote:
> 
> Hi Guys, I have a 95 gpz1100 that I'm tryng to ressurect.  It has pod
> filters and I'm assuming a jet kit in it.
> 
> I don't have a book for it and I'm trying to set the float heights.  I have
> read that they are the same carbs as the early zrx1100 (which I do have a
> book for) and so I am setting the float height to 18.5 mm as indicated in
> the zrx1100 book.
> 
> Can anyone confirm that this is the correct height?
> 
> Thanks,
> 
> -Pete
> ______________________________________________________________________
> GENERAL GPZList MAILING LIST INFORMATION:
> This is from the GPZList mailing list. GPZList at micapeak.com
> http://micapeak.com/mailman/listinfo/gpzlist
> You subscribed to this mailing list. Therefore, you solicited all
> mail that you receive from this list. Therefore, ANY mail that you
> receive from this list is, by definition, NOT Spam, and if you report
> it as such, you are violating the micapeak.com terms of service.
> 
> To unsubscribe, you may send email to gpzlist-unsubscribe at micapeak.com
> ______________________________________________________________________
> YOUR PERSONAL SUBSCRIBER OPTIONS:
> Unsubscribe or choose new options at
> http://micapeak.com/mailman/options/gpzlist/art-j%40shaw.ca
> You are subscribed at the email address art-j at shaw.ca
> ______________________________________________________________________