not good, bad, real bad
darkclarity2k at yahoo.com
Mon Aug 20 08:55:19 PDT 2007
Thats got to feel good. Horray!!!
Robert Nelson <majordad at carolina.rr.com> wrote: Ok, forget my last email because I am apparently even dumber than I thought.
After the response from 1KPerDay I decided to look through the shop manual
to see what is involved with getting to the bottom of the cam chain.
Imagine my dumbfounded expression as the light bulb goes on when I see that
the bottom of the cam chain is at the crankshaft where I have been adjusting
the camshaft to TDC. So, full of positive expectations I go out to the
garage and look in there and the shim is setting right out in the open.
Problem averted and information learned.
From: 1KPerDay [mailto:1kperday at gmail.com]
Sent: Monday, August 20, 2007 11:18 AM
Cc: gpzlist at micapeak.com
Subject: Re: not good, bad, real bad
I've heard of some who removed the timing cover at the left of the
engine and were lucky enough to find the dropped shim in there...
dunno if it's possible on the GPz or not. Couldn't hurt to take it off
As for this: "I believe there is very little chance of the shim being
I'm afraid I don't share your belief. ;)
If you do decide to run the bike, I'd personally run it for a short
time and then remove the oil pan (the whole oil pan) and hope you find
the shim somewhere in there. Again, you could get lucky.
On 8/20/07, Robert Nelson wrote:
> I don't believe that there is any other way to open up that area other
> pulling the head which seems awfully drastic. I have turned the
> and never heard any more sounds so I believe there is very little chance
> the shim being a problem. But I figured it would not hurt to ask if
> else has had this problem and had any issues. Any thoughts, besides
> me an idiot, are appreciated. Thanks!
More information about the GPZList