not good, bad, real bad

Marilyn Mason masonjs at
Mon Aug 20 09:11:29 PDT 2007

Just remeber before you button the bike up to remove the paper towel.  I
recall Charlie Blum (Rest his soul) neglected this and had to tear down his
engine to remove the bits of toweling.

----- Original Message ----- 
From: "Robert Nelson" <majordad at>
To: "'1KPerDay'" <1kperday at>
Cc: <gpzlist at>
Sent: Monday, August 20, 2007 11:52 AM
Subject: RE: not good, bad, real bad

> Ok, forget my last email because I am apparently even dumber than I
> After the response from 1KPerDay I decided to look through the shop manual
> to see what is involved with getting to the bottom of the cam chain.
> Imagine my dumbfounded expression as the light bulb goes on when I see
> the bottom of the cam chain is at the crankshaft where I have been
> the camshaft to TDC.  So, full of positive expectations I go out to the
> garage and look in there and the shim is setting right out in the open.
> Problem averted and information learned.
> Much relieved!
> Bob
> -----Original Message-----
> From: 1KPerDay [mailto:1kperday at]
> Sent: Monday, August 20, 2007 11:18 AM
> Cc: gpzlist at
> Subject: Re: not good, bad, real bad
> I've heard of some who removed the timing cover at the left of the
> engine and were lucky enough to find the dropped shim in there...
> dunno if it's possible on the GPz or not. Couldn't hurt to take it off
> and check...
> As for this: "I believe there is very little chance of the shim being
> a problem."
> I'm afraid I don't share your belief. ;)
> If you do decide to run the bike, I'd personally run it for a short
> time and then remove the oil pan (the whole oil pan) and hope you find
> the shim somewhere in there. Again, you could get lucky.
> On 8/20/07, Robert Nelson <majordad at> wrote:
> > I don't believe that there is any other way to open up that area other
> than
> > pulling the head which seems awfully drastic.  I have turned the
> crankshaft
> > and never heard any more sounds so I believe there is very little chance
> of
> > the shim being a problem.  But I figured it would not hurt to ask if
> anyone
> > else has had this problem and had any issues.  Any thoughts, besides
> calling
> > me an idiot, are appreciated.  Thanks!
> >
> -- 
> Utah Jeff
> '96 SheePz1100

More information about the GPZList mailing list