Hard (impossible) to start
steven at bixbys.net
Sun Apr 24 16:50:54 PDT 2011
On a related note.... I actually have a can of "Berryman Chem-Dip"
that I meant to use, once.
Anyone have experience with this stuff on it's own?
I also wonder if it would be a good agent in an ultrasonic cleaner.
On 4/24/2011 12:34 PM, Steven Bixby wrote:
> I wonder if the typical ultrasonic cleaner rigs you can get on the
> consumer market would do the job? Or do they have some special
> nuculear-powered-atomic-blast-resistant units?
> I've wanted to get a reasonably capable ultrasonic cleaner for home use,
> perhaps off eBay. I have more than just carburetor-cleaning in mind, too.
> On 4/24/2011 12:19 PM, Charles Scappaticci wrote:
>> Carbs gunk up, that's just a fact. When I reinstalled my jetted
>> carbs, they had sat for a couple of years and I knew they weren't that
>> clean when I had taken them off. I had the local dealer do a thorough
>> ultrasonic cleaning and reinstalled them. Three years later, it
>> starts at the touch of the button on it's five year old battery. I
>> can almost guarantee you it will run and start a lot better when they
>> are done. The dealer here charges $75 per carb for cleaning (Vickery
>> Motorsports) and the ultrasonic cleaning will do better that you can.
>> Charles S.
> GENERAL GPZList MAILING LIST INFORMATION:
> This is from the GPZList mailing list. GPZList at micapeak.com
> You subscribed to this mailing list. Therefore, you solicited all
> mail that you receive from this list. Therefore, ANY mail that you
> receive from this list is, by definition, NOT Spam, and if you report
> it as such, you are violating the micapeak.com terms of service.
> To unsubscribe, you may send email to gpzlist-unsubscribe at micapeak.com
> YOUR PERSONAL SUBSCRIBER OPTIONS:
> Unsubscribe or choose new options at
> You are subscribed at the email address STEVEN at bixbys.net
More information about the GPZList