Rear Wheel Install

Dennis gpzeer at
Tue Jun 7 10:55:06 PDT 2011


There is no flat washer between the spacer and the disc brake bracket, just 
the top hat shaped spacer.  The only flat washer goes just under the axle 
nut as you have said.  The axle can be installed from either direction, it 
makes no difference, just a matter of personal preference.  I install mine 
from the chain side so that the nut is on the brake side.

Hope this helps.

Dennis Peterson
95 RED
Orem, UT   USA

From: "Les Johnson" <jjohnsonlta at>
Sent: Tuesday, June 07, 2011 6:50 AM
To: "Dennis Peterson" <gpzeer at>
Subject: Rear Wheel Install

>     Took my rear wheel off my 96 GPZ last week. Can't quite remember
> if there was a flat washer between spacer on disc brake side and disc
> brake caliper bracket. I had two flat washers and from the parts
> blowup it looks like just one is used behind axle nut. It also states
> axle installs from left side with nut on brake side but it looks
> opposite in blowup. I'll swear mine was opposite but maybe it doesn't
> matter.
> Can someone clear this up for me?
>     Thanks   Les J
> ______________________________________________________________________
> This is from the GPZList mailing list. GPZList at
> You subscribed to this mailing list. Therefore, you solicited all
> mail that you receive from this list. Therefore, ANY mail that you
> receive from this list is, by definition, NOT Spam, and if you report
> it as such, you are violating the terms of service.
> To unsubscribe, you may send email to gpzlist-unsubscribe at
> ______________________________________________________________________
> Unsubscribe or choose new options at
> You are subscribed at the email address gpzeer at
> ______________________________________________________________________

More information about the GPZList mailing list